NAS Codex › QNAP
QNAP NAS errors and statuses
12 guides. Each one is written from QNAP's own knowledge base, help pages or hardware guide, linked on the page.
- QNAP "Disk X: Medium error" in the system log: what it means and what to doQNAP log says "[Hardware Status] Disk X: Medium error."? What QNAP says it means, how to check Disk Health and run a S.M.A.R.T. test, and when to replace it.
- QNAP "[Disk S.M.A.R.T.] Disk x still has warning/error condition": what to doQNAP keeps logging "[Disk S.M.A.R.T.] Host: Disk x still has warning/error condition"? What Warning and Error health mean, and QNAP's disk replacement steps.
- QNAP disk status shows "Inactive" (or "Disk drive X failed or is unplugged")QNAP Storage & Snapshots shows a disk as Inactive? QNAP says the NAS cannot detect the disk in that bay. Its checks in a safe order, and when to replace it.
- QNAP "RAID group X is degraded, the RAID group has been set to read-only"QNAP shows "Warning (Degraded - Readonly)" and says to back up all files immediately? Why QNAP says not to replace a disk first, and the order it gives instead.
- QNAP RAID rebuild won't start after replacing a drive in a degraded poolReplaced a failed disk in a degraded QNAP pool and the rebuild never started? QNAP's Configure Spare Disk fix, drive checks first, and when it doesn't apply.
- QNAP firmware update error FW004: "A flash read/write error occurred"QNAP firmware update fails with "A flash read/write error occurred. Error code: FW004"? Which models and QTS versions QNAP lists, and its two-step update route.
- QNAP NAS won't boot after a QTS firmware updateQNAP NAS stuck after a firmware update? QNAP's test: remove the drives, boot again, and listen for the long beep within 4 minutes. What each result points to.
- QNAP status LED flashing red and green alternately: what it meansQNAP status LED flashing green and red alternately? QNAP says the NAS is busy: formatting, initializing, updating firmware or rebuilding RAID. Mostly, you wait.
- QNAP status LED red: flashing red vs solid red, and what each meansQNAP status LED red? Flashing red means degraded mode; solid red covers disk, volume, fan and self-test faults. QNAP's LED table and where to look for each.
- QNAP NAS can't be accessed and the status LED is flashing greenQNAP status LED flashing green and you can't reach the NAS? QNAP's three steps: Qfinder Pro search, 3-second reset that keeps data, then a boot without disks.
- QNAP beep codes: one long, two long, three short and one longWhat QNAP NAS beeps mean: one short at start-up, three short plus one long every 5 minutes for a fan failure, two long for degraded mode, and the boot beeps.
- QNAP NAS stuck while booting: disk problem or hardware fault?QNAP NAS stuck while booting and never finishes? QNAP's test is to boot without any disks, then add them back one at a time to find the disk that stops it.