NAS Codex › QNAP › QNAP status LED flashing red and green alternately: what it means

QNAP status LED flashing red and green alternately: what it means

The status LED on the front of the QNAP is alternating between green and red. It looks alarming, but in QNAP's documentation this pattern means the NAS is in the middle of an important operation, not that something has failed.

Written against: QNAP Turbo NAS user manual LED table (QTS 4.2.x) and QNAP FAQ last modified 2026-06-16. Last Updated: November 2026. Vendor menus and wording change between versions; if yours differ, follow the vendor page linked under Sources.

Before anything else: if the data on this NAS is not backed up somewhere else, copy it off first. Do not continue with any step on this page until you have.

Fast Answer

Leave it alone. QNAP's LED table says green and red flashing alternately every 0.5 sec means a disk is being formatted, the NAS is being initialized, the firmware is being updated, or a RAID rebuild, online capacity expansion or online RAID level migration is in progress. Do not power off, restart or pull drives while it is flashing like this. Check progress in Storage & Snapshots if you can log in.

What QNAP's LED table says

QNAP's NAS user manual (the QTS 4.2.x LED and alarm buzzer table) lists six conditions for the status LED that "Flashes green and red alternately every 0.5 sec":

QNAP's 2026 FAQ on status LEDs repeats it: "If the Status LED is flashing red and green alternately, the NAS may be performing an important operation such as disk formatting, firmware update, RAID rebuilding, or capacity expansion."

Work out which operation it is

What not to do while it flashes

Do not power off, unplug, restart or remove disks while the LED alternates red and green. Each of the six operations QNAP lists writes to the disks or the firmware, and interrupting a firmware update is the cause QNAP gives for a corrupted firmware image.

When the flashing should change

When the operation finishes, the LED should move to one of the other states in QNAP's table. The ones you are most likely to see next:

Status LEDQNAP's meaning
GreenThe NAS is ready.
Flashes red every 0.5 secThe NAS is in degraded mode (one member hard drive fails in RAID 1, RAID 5 or RAID 6 configuration).
RedA fault such as an invalid disk, a full volume, a fan failure, a disk read/write error or bad sector, degraded read-only mode, or a hardware self-test error. See status LED red.
Flashes green every 0.5 secThe NAS is starting up, is not configured, or the hard disk drive is not formatted. See flashing green.

If a rebuild finishes and the LED goes to flashing red or solid red, the rebuild did not leave the pool healthy. Check Storage & Snapshots before doing anything else.

When to stop and get help

If the LED has alternated for a very long time and you cannot log in to see what the NAS is doing, do not cut the power on a guess. Contact QNAP support, especially if a firmware update was running.

Questions

Why is my QNAP status light flashing red and green?

QNAP's LED table says it means a disk is being formatted, the NAS is being initialized, firmware is being updated, or a RAID rebuild, online capacity expansion or online RAID level migration is in progress.

Can I turn off my QNAP while the light flashes red and green?

No. Each operation QNAP lists writes to the disks or firmware. QNAP says not to power off the device during a firmware update.

What should the status LED show when it is done?

In QNAP's table, solid green means the NAS is ready. Flashing red means degraded mode; solid red indicates a fault to investigate.

Sources

Every fact on this page comes from the vendor documents below, opened on 2026-11-13.