NAS Codex › Synology › Synology "Number of bad sectors increased": is the drive failing?

Synology "Number of bad sectors increased": is the drive failing?

DSM sends a Number of bad sectors increased alert, or a drive's Bad sector count is no longer 0. Synology's own view is measured: bad sectors are "a common phenomenon for HDDs", and as long as the increase is not drastic there should be no cause for concern. What matters is the trend, and the drive's status in Storage Manager.

Written against: Synology Knowledge Center article with Environment DSM 6.2 to 7.2 (for DSM 7.2.1 and above Synology says to go by the drive status in Storage Manager). Last Updated: November 2026. Vendor menus and wording change between versions; if yours differ, follow the vendor page linked under Sources.

Before anything else: if the data on this NAS is not backed up somewhere else, copy it off first. Do not continue with any step on this page until you have.

Fast Answer

Open Storage Manager > HDD/SSD, select the drive, click Health Info and go to History > Key Information of Drives. If the Bad sector count graph is stable, keep monitoring. If it is rising rapidly, the drive may fail; Synology suggests replacing it if it enters Critical status. On DSM 7.2.1 and above, the drive status itself tells you whether to replace it.

What a bad sector is, per Synology

Synology describes bad sectors as segments of a drive that are defective and cannot be accessed, typically from mechanical damage. They tend to develop over time and with use, and it is not unusual for new drives to have some. DSM marks them so they are skipped in future. Synology says you can keep using the drive as long as it is in a healthy status.

Where you see it

Read the graph

  1. Go to Storage Manager > HDD/SSD.
  2. Select the suspected drive.
  3. Click Health Info and go to History > Key Information of Drives.
  4. Check the Bad sector count graph:
    • Stable: the bad sectors may have been corrected. Keep monitoring.
    • Increasing rapidly: the drive may fail in future. Synology suggests replacing it if it enters Critical status.

Synology also recommends running data scrubbing twice a year to keep data consistent and avoid data loss if a drive fails.

Replacing the drive: Synology's steps

Check the replacement against the Synology Products Compatibility List for your model. Then follow the route for your RAID type.

RAID types without data protection

Warning: Synology's steps for this case start with a full backup and end with creating a new storage pool and volume and restoring into them. Do not skip step 1.

  1. Back up all your data.
  2. Power off the NAS.
  3. Remove and replace the defective drive.
  4. Power on. On a one-bay model, install DSM.
  5. Create a new storage pool and volume.
  6. Restore the backed-up data.

RAID types with data protection

When to stop and get help

Stop and back up if the count is climbing fast, if the drive moves to Critical or Failing, or if a second drive in the same pool also shows bad sectors. Do not pull a drive from a pool without data protection until the backup is complete.

Questions

Is one bad sector on a Synology drive a reason to replace it?

Not on its own. Synology says bad sectors are common on HDDs and there is no cause for concern as long as the increase is not drastic. Replace when the count rises rapidly and the drive enters Critical status.

Where is the bad sector count in DSM?

Storage Manager > HDD/SSD, select the drive, click Health Info, then History > Key Information of Drives, and look at the Bad sector count graph.

What does Synology say for DSM 7.2.1 and later?

Synology's note says that for DSM 7.2.1 or above, check the drive status shown in Storage Manager > HDD/SSD to decide whether the drive needs replacing.

Sources

Every fact on this page comes from the vendor documents below, opened on 2026-11-14.